• Benewake TFmini LiDAR
    • 硬件安装
    • Parameter Setup

    Benewake TFmini LiDAR

    The Benewake TFmini LiDAR is a tiny, low cost, and low power LIDAR with 12m range. It must be connected to a UART/serial bus.

    TFmini LiDAR

    硬件安装

    TFmini can be connected to any unused serial port (UART), e.g.: TELEM2, TELEM3, GPS2 etc.

    Parameter Setup

    Configure the serial port on which the lidar will run using SENS_TFMINI_CFG. There is no need to set the baud rate (this is hard coded in the sensor driver as only one rate is supported).

    Note If the configuration parameter is not available in QGroundControl then you may need to add the driver to the firmware: drivers/distance_sensor/tfmini